CLONE:
Please note the below conditions before clone:
- Bay ‘A’ = SOURCE HDD,
- Bay ’B’ = TARGET HDD
- TARGET HDD ‘s capacity MUST be larger than SOURCE
HDD, otherwise the CLONE cannot be completed. (Same
capacity is also not acceptable)
- Before CLONE function starts, make sure the information
in TARGET HDD is not important; once CLONE started, all
information from the SOURCE HDD will be covered into
TARGET HDD..
- Once the docking is connected to USB interface, the offline
Clone will be invalid. Clone can only process by using USB
Clone Function.
1, Offline clone
a、Insert source HDD to Bay ‘A’; target HDD to Bay ‘B’, and then
turn on the power
To Next Page
Loading...