NOTE: All child safety restraint systems should always face the front or rear
of the motor home. They should never be installed so the occupant is facing the
side of the motor home.
INSTRUMENT PANEL
For more information refer to your Chassis Guide.
SIDE VIEW POWER MIRRORS (IF SO EQUIPPED)
After adjusting the front driver’s seat, adjust the exterior side view power mirrors to
your driving preference.
Power remote mirrors
You can adjust the power remote mirrors when the ignition key is in the ON or
ACC position.
1. Move the control knob to the side you want to adjust.
2. Press the control arrows in the direction you want the mirror to move.
3. Return the control knob to the center to lock the mirror(s) into place.
The power remote mirrors also contain heating elements to defog or de-ice the
mirrored glass if needed. To activate this feature, use the “Mirror Heat” control
located on the driver’s side console next to the mirror control.
NOTE: To prevent the batteries from running down, operate the power remote
mirrors when the chassis engine is running.
REAR VISION CAMERA
Your motor home is equipped with a rear vision monitor that gives a limited
televised view of what is behind your motor home. The rear vision camera will aid
you in backing up the motor home, and can be used for a greater field of vision
when driving in heavy traffic.
Check the outside rear view mirrors when driving and backing up the motor home
for a more complete field of vision.
Objects in the camera/monitor view can be closer than they appear. To become
accustomed to using the rear view camera monitor, practice backing up in a safe
place. If in doubt, ask another person outside the vehicle to assist.
The monitor is operational whenever the engine is running. To use the monitor, flip
the switch from standby to ON (the monitor will also work when with the motor
home is in “reverse” and the monitor in standby). Make sure you turn the
monitor to standby while driving to avoid being distracted.
Never operate the rear vision monitor in the ON position for extended periods of
time as this may result in an "image burn" on the monitor.
WARNING
Do not set anything on or attach anything to the instrument panel or dash. Do
not attach anything to the steering wheel cover such as trim material, badges,
etc. Failure to follow these warnings may restrict the driver's visibility or cause
an object to strike and injure an occupant in the case of a collision or sudden
To Next Page
Loading...
Need help?
General
