Jayco 2015 PRECEPT User Manual

JAYCO CLASS A MOTOR HOMES SECTION 5 – SLIDEOUT SYSTEMS
5-3
Slideout override
Locate and remove the access panel for the slideout motor.
Fig. 5.5 Main room slideout motor
1. From the rear of the motor, rotate the brake release lever counter-clockwise
1/8 turn. This will release the brake that locks the slideout in place.
2. Disconnect one slideout motor wire near the motor.
3. The slideout is now free to move. Locate the access panel either at the front
or rear of the slideout rail. Remove the access panel for the manual slideout
shaft.
4. Use a 3/4 socket and ratchet on the hex head located on either end of the
drive shaft and turn the shaft until the slideout is in the position you desire.
When the slideout is fully extended (or retracted), put pressure on the wrench
to ensure a tight seal, then return the brake release lever to its normal
downward position. This will ensure that the slideout is locked into a sealed
position
.
WARNING
Do not work on your system unless the battery is disconnected. Failure to
comply could result in death or serious injury.
CAUTION
When the slideout motor brake is released, the slideout will not lock into
place, and therefore it will not be sealed from the outdoors! When the slideout
has been retracted, return the brake release lever to its downward position in
order to seal and lock the slideout.

Jayco 2015 PRECEPT Specifications

General

Model Year	2015
Brand	Jayco
Model	PRECEPT
Category	Motorhomes
Chassis	Ford
Fuel Type	Gasoline
Transmission	5-speed automatic
Sleeping Capacity	6
Slideouts	2
Horsepower	362 hp
Torque	457 lb-ft
Gross Vehicle Weight Rating (GVWR)	22, 000 lbs
Fuel Capacity	80 gal
Engine	6.8L Triton V10