8-12
When you are finished draining the fresh water system, reverse these steps and
dump the grey and black water holding tanks at an appropriate facility or according
to local public codes.
UTILITY CENTER
The following information defines the function of the utility center settings indicated
on the utility center label:
City Fixtures - This setting allows you to access water at all faucets using city
water.
City Tank Fill - This setting allows you to fill your fresh water tank using city
water.
Country Fill - This setting allows you to fill your fresh water tank (using the 12-volt
water pump) when you do not have access to city water.
Normal - If the RV is not connected to city water, this setting allows you to pump
water from the fresh water tank to all faucets using the 12-volt water pump.
Sanitize/Winterize Lines – This setting allows you to sanitize or winterize your
fresh water system.
Sanitize Tank – This setting allows you to sanitize the fresh water tank.
The city water connection inlet is located in the utility compartment. We
recommend that you use a non-toxic drinking water hose dedicated only to
supplying the motor home with fresh water (to reduce the chance of
contamination, prevent the non-toxic drinking water hose from coming into contact
with the ground). Install the city water connection inlet cap when the fresh water
connection is not being used. Do not remove the following label from your motor
home
:
Fig. 8.5 Potable water only label
To Next Page
Loading...
Need help?
General
