CHAPTER
VII
MAINTENANCE
REMOVING
TZRE
&
WHEE5
FROM
TENT
CAMPER
1.
Unhook trailer from car.
2.
Lower tongue as low as possible.
3.
Swing
down
rear corner stabilizer jack and extend as far as
possible.
4.
Loosen
lug
bolts.
5.
Raise front end with tongue jack until wheel clears from ground.
6.
Remove lug bolts.
7.
Remove tire and wheel.
On
Flight Series
1982
and older (closed wheel well trailers):
A.
To remove tire it is easier to push bottom side of tire to the center
of
the trailer and then tip the top side outward untiI the tire and
wheel lays flat on the ground. This is to clear the
wheel
hub.
B.
It may
be
necessary to loosen two
(2)
lug bolts, drive forward, and
loosen the other two
(2)
lug bolts before unhooking from the car
and raising up the camper.
C.
On
the Flight
6
with the 8-inch wheels, you may not have enough
clearance to swing down the stabilizer jack for support.
Extra
clearance can be achieved by:
1
Using a separate jack to raise the trailer, preferably hydraulic,
screw jack, or scissor jack, etc.
2.
Driving the trailer onto several pieces of wood blocking
you
may be carrying for using in campgrounds. They should be
preferably
2
x
6
wood blocks.
NOTE:
There
may
-be
situations
where the
unhooking
of
the
trailer
may
not
be necessary.
This
Instruction
sheet
is
intended
to
recommend
de£in£te
workable
methods.
To Next Page
Loading...
