95
Make sure the LP gas supply is turned ON.
Turn on the 12VDC power in the RV.
Open the water heater access door.
Turn the power switch on by selecting either ECO or
COMFORT position. The green LED () will light at the
top of the power switch.
If the RED LED () below the switch lights or ashes,
it indicates an error condition. Refer to the appliance
owner manual for error codes.
Inspect your water heater monthly and have it serviced at
least once a year by the manufacturer’s recommended ser-
vice technician. Contact your RV dealer, the manufacturer or Customer Service.
The water heater is
running in energy saving mode. Pro-
pane gas is used to prevent freezing.
The temperature in the water heater
is automatically kept above 41°F
(5°C). Water temperature coming
out of the xtures is approximately
120°F (49°C). When the water heat-
er is running in ECO MODE, a yel-
low LED (3) will be lit in the middle
of the rotary dial control switch in-
side the RV.
Valve is not serviceable; if defective it must be replaced.
Tampering with the valve will result in scalding injury. Do not place a
plug or reducing coupling on the outlet part of the valve. If you use a
discharge line allow complete drainage for both valve and line.
Tampering with the valve will void the warranty.
To Next Page