96
The appliance is running in a mode
that provides rapid availability of hot water. Water tem-
perature at the xtures is 120°F (49°C).
System is operating in Stand By Heat, which keeps water
temperature in the appliance at 102°F (39°C). While run-
ning in COMFORT MODE the yellow status LED (3) on
the rotary dial will be lit.
When the power switch is OFF, the appliance is not run-
ning in any operating mode. Yellow status LED (3) on the
rotary dial is NOT lit.
Preven-
tion of freezing using 12VDC electricity. If the acces-
sory electric antifreeze kit is installed, and the appliance
switched ON, the temperature in the water heater is au-
tomatically held above 41°F (5°C). During operation the
yellow status LED (3) is lit.
This mode is only available on the Aqua Go COM-
FORT or COMFORT PLUS models. For safety reasons after 30 seconds the de-
calcication process cannot be stopped until the system has been rinsed (Refer to
Decalcication and Rinsing the System).
The Aqua Go water heater does not have a conventional
drain plug. Instead it includes a “drain chute”.
Water heater power should be OFF, water pump
OFF, and xtures open to relieve pressure on
the plumbing system.
Open the water heater exterior door to the “ser-
vice” position hanging by the straps.
Open the drain chute by pushing UP on the
black button above the yellow label on the left
side of the water heater (). This releases the
drain chute.
Push the chute all the way open which will
dump water out of the water heater away from
the side of your RV. Water heater contains ap-
proximately 1.5 liters of water.
Drain all the water out of the water heater.
The water inlet lter is located inside the drain
chute (). The lter will pull out of the open-
ing in the drain chute. Rinse it with clean water,
inspect O-rings for cracks.
To close the drain chute, push it up until it
latches back into place. You will hear an audible
“click” when the chute engages.
To Next Page