91
MAINTENANCE CHECKLIST
Prior to First Trip
q
Check LP gas lines for leaks.
q Test carbon monoxide detector (Generator/Generator Prep option only.)
q Test LP gas detector.
q Sanitize fresh water system.
q Tighten wheel nuts to specified torque values.
q Open all windows and the door and start the furnace. Leave the windows and
door open and the furnace on until all fumes fully dissipate.
First Ten Miles
q
Tighten wheel nuts to specified torque values.
First Twenty-Five Miles
q
Tighten wheel nuts to specified torque values.
First Fifty Miles
q Tighten wheel nuts to specified torque values.
First Two-Hundred Miles
q Tighten wheel nuts to specified torque values.
q Have brakes adjusted by a qualified service technician.
Each Trip
q Test LP gas detector.
q Check battery water level. (If equipped with battery.)
q Check brake fluid level in master cylinder reservoir. Keep filled to within ½”
from top of reservoir.
q Check master cylinder cap for tightness.
q Check tire pressure and wear.
q Check running lights.
q Inspect safety chains for signs of wear.
q Test brakes.
After Every Tire Change
q Tighten wheel nuts to specified torque values at ten miles, twenty-five miles
and fifty miles.
Daily
q Recharge battery after each use.
q Ensure LP gas detector operation light is green in color.
Weekly
q Test LP gas detector.
q Check tire pressure and wear.
To Next Page
Loading...
Need help?
General
