To Next PageTo Next Page
Need help?Do you have a question about the JB Systems BEAT 4 Mk2 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Microphone Inputs | 2 |
| Line Inputs | 4 |
| USB Interface | Yes |
| Dimensions | 320 x 270 x 90 mm |
| Inputs | 4 Line, 2 Microphone |
| Power Supply | External power adapter |
| Outputs | Master, Booth |
| EQ | 3-band EQ per channel |
| Crossfader | Replaceable crossfader |
Input for unbalanced microphone with XLR connector, also has 1/4" mono jack.
Selects correct input for each channel: Phono, line, aux, or mic.
Adjusts the input level for each channel to about OdB on the VU-meter.
Controls frequency for each channel separately, flat at center position.
Mutes input channels 2-4 when speaking into the DJ microphone.
Selects channels for monitoring via headphone output. Allows mixed sound monitoring.
Sets the playback level for each channel separately.
Selects channels for crossfader and beat counters. '0' switches crossfader off.
Shows BPM of the selected channel. Requires clear, steady beat for accuracy.
LEDs indicate synchronization of beat counters for mixing two audio sources.
Mixes selected channels; integrates optical fader starts for CD players.
Enables/disables fader start control for compatible CD players via crossfader.
Monitors Master1 output level. Avoid levels exceeding 0dB to prevent distortion.
Monitors selected channel level via PFL-switch. Avoid levels exceeding 0dB.
Controls the output level of the headphone output.
Mixes master output and input channels through headphone output for pre-mix checks.
6.3mm jack for monitoring all inputs/outputs with stereo headphones.
Adjusts the output level of the balanced Master1 output.
Adjusts the balance between left and right output on Master1.
Adjusts the output level of the unbalanced Master2 output.
Turns the mixer power on and off. Blue LED indicates power status.
Connects compatible CD-players for control via mixer fader starts.
Connects to a 230V/50Hz mains outlet. Inspect for damage before use.
Connects turntable signal ground to the mixer's GND connector.
XLR connectors for connecting to balanced amplifier inputs.
Unbalanced outputs mirroring Master1 and independently controlled Master2.
Output signal for analog recording equipment, unaffected by master controls.
Connects two different line level audio signals per channel.
Connects a line level audio signal to channel 1.
1/4" mono jack alternative to the front XLR microphone input.
Switches line inputs on channels 2, 3, 4 between CD and phono levels.
