JBL COL Series - Page 4

4
CAUTION: Installation must be done by skilled
persons using safe installation standards.
The COL speaker can be attached to the wall either using the included SWIVEL/TILT WALL BRACKET or using the two included L-
BRACKETS.
OPTION A: WALL SURFACE MOUNTING VIA
INCLUDED SWIVEL/TILT WALL BRACKET
Note that the BRACKET ASSEMBLY consists of a SPEAKER-SIDE and a WALL-SIDE.
1.0) Mounting WALL-SIDE BRACKET:
1.1) Run the wiring from the power amplifier to the location desired for mounting the JBL COL loudspeaker.
1.2) Secure WALL-SIDE BRACKET to wall using the appropriate installer-selected attachment hardware, and using a level to
ensure that the WALL-SIDE BRACKET is straight. Use both screw holes of WALL-SIDE BRACKET. Be sure that the TILT-SET
SLOT is at the top and HOOK SLOT is at the bottom. After attaching to the wall, slide plastic TRIM COVER over bracket and
snug to wall.
Hardware for attaching WALL SIDE of Bracket to wall is not included. The installer
is responsible for proper selection and use of mounting hardware and for properly
and safely securing the bracket to the wall material.
TILT-SET SLOT
(on the top)
HOOK SLOT
(on the bottom)
TRIM COVER
(slide over WALL-SIDE
BRACKET after bracket gets
secured to wall)
Dia Ø6.5 [0.26]
UP