How to fix JBL CSR-V if the green LED is not lit?
If the green LED on your JBL Remote Control below the Source switch (labelled ACTIVE) is not lit, check that the P11 jumper is correctly installed.
General| Brand | JBL |
|---|---|
| Model | CSR-V |
| Category | Remote Control |
| Language | English |
Explains how the remote's source selection works on the mixer when the zone is set to REMOTE.
Details the steps for setting the remote control's volume attenuation, which is ATTENUATE ONLY.
Solution for the green LED on the remote control not being lit, checking the P11 jumper.
Steps to check for malfunctions between the remote control and the mixer using pin definitions.
To Next Page
