IMPORTANT
SAFETY
INSTRUCTIONS
II.
FOR
ALL
PRODUCTS:
CAUTION
RISK
OF
ELECTRIC
SHOCK.
DO
NOT
OPEN.
THE
LIGHTNING
FLASH
WITH
AN
ARROWHEAD
SYMBOL,
WITHIN
AN
EQUILATERAL
TRIANGLE,
IS
INTENDED
TO
ALERT
THE
USER
TO
THE
PRESENCE
OF
UNINSULATED
"DANGEROUS
VOLTAGE"
WITHIN
THE
PRODUCT'S
ENCLOSURE
THAT
MAY
BE
OF
SUFFICIENT
MAGNITUDE
TO
CONSTITUTE
A
RISK
OF
ELECTRIC
SHOCK
TO
PERSONS
THE
EXCLAMATION
POINT
WITHIN
AN
EQUILATERAL
TRIANGLE
IS
INTENDED
TO
ALERT
THE
USER
TO
THE
PRESENCE
OF
IMPORTANT
OPERATING
AND
MAINTENANCE
(SERVICING)
INSTRUCTIONS
IN
THE
LITERATURE
ACCOMPANYING
THE
PRODUCT
WARNING:
TO
REDUCE
THE
RISK
OF
FIRE
OR
ELECTRIC
SHOCK,
DO
NOT
EXPOSE
THIS
APPARATUS
TO
RAIN
OR
MOISTURE.
FCC
AND
IC
STATEMENT
FOR
USERS
(USA
AND
CANADA
ONLY)
This device complies with part
15
of the
FCC
Rules.
Operation
IS
subject to
the
follow1ng
two
conditions:
(1)
This
device may not cause harmful
interference, and
(2)
this
dev1ce
must accept
any
interference received, including Interference that
may cause undesired operation.
This
Class B digital apparatus complies with
Canadian
ICES-003.
Cet appareil numenque de
Ia
classe B est
conforme
a
Ia
norme NMB-003 du Canada.
FEDERAL
COMMUNICATION
COMMISSION
INTERFERENCE
STATEMENT
This
equ1pment
has
been tested and found
to comply with the limits for a
Class B digital
device, pursuant to
Part
15
of
the
FCC
Rules.
These limits
are
designed to
prov1de
reasonable
protect1on
against harmful interference
in
a
resldentlal1nstallat1on.
This
equ1pment
generates,
uses and can
radiate radio frequency energy
and.
1f
not Installed and used
in
accordance
w1th
the
1nstruct1ons,
may cause harmful Interference
to
rad1o
communications. However, there
1s
no
guarantee that interference
will
not occur
in
a
bvHARMAN
particular installation.
If
this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user
is
encouraged
to try to correct the interference by one or more of
the
following measures:
• Reonent or relocate the receiving antenna.
• Increase
the separation between the equipment
and
receiver.
• Connect the equipment into
an
outlet on a
circuit different from that to which the receiver
is
connected.
• Consult the dealer or
an
experienced radiot1V
technician for help.
Caution:
Changes or modifications not expressly
approved
by
HARMAN could void the user's
authority to operate the equipment.
FOR
PRODUCTS
THAT
TRANSMIT
RF
ENERGY:
FCC
AND
IC
INFORMATION
FOR
USERS
This device complies with Part
15
of the
FCC
rules
and Industry Canada license-exempt
RSS
210. Operation
is
subject to the following two
conditions
(1)
This
device may not cause harmful
interference; and
(2)
this device must accept any
interference received,
including interference that
may cause
undeswed
operation.
FCC/IC
Radiation
Exposure
Statement
Th1s
equipment complies with FCC/IC RSS-
1 02 radiation exposure limits set forth for
an
uncontrolled environment. This equipment should
be
installed and operated with minimum distance
20cm between the radiator
& your
body.
FOR
PRODUCTS
WITH
RADIO
RECEIVERS
THAT
CAN
USE
AN
EXTERNAL
ANTENNA
(USA
ONLY):
CATV
(CABLE
TV)
OR
ANTENNA
GROUNDING
If
an
outsine antenna or cable system
is
connected
to
th1s
product, be certain that
it
is
grounded so
as
to proviae some protection against voltage surges
and static charges. Section
810 of the National
Electncal Code
(NEC),
ANSI/NFPA
No.
70-1984,
prov;des information with respect to proper
grounding of the mast and supporting structure,
grounding of the
lead-in wire to
an
antenna
discharge unit, size of grounding conductors,
location of antenna discharge unit, connection
to grounding electrodes and requirements of the
grounding electrode.
NOTE
TO
CATV
SYSTEM
INSTALLER:
This reminder
IS
provided to
call
the
CATV
(cable
TV)
system installer's attention to article 820-40
of the
NEC,
which provides guidelines for proper
grounding and,
1n
particular, specifies that the
cable ground
shall
be connected to the grounding
system of the building,
as
close to the point of
cable entry
as
possible.
To Next Page
Loading...
Need help?
General
