CLEANING SOLUTIONS
Approved cleaning solutions water/household detergents (ph6-b).
WARNING
The pump of your parts washer may be damaged if you use solvents other than those
listed above such as methyl ethyl ketone (MEK), perchloroethylene or trichloroethylene.
TROUBLE SHOOTING
The only trouble you should ever experience with your parts washer is reduced volume
flow or no flow of cleaning liquid from the flex hose nozzle. The probable cause is
foreign matter in the flex hose.
CORRECTIVE PROCEDURE
1. Check that indicator light on switch box is lit.
2. Using an insulated handle screw driver to lightly touch tip of housing of motor. A
light oscillation
magnetic pull indicates
power is reaching the motor.
3. Disconnect power plug, remove flex hose from pump flow - out line.
4.
Remove front of
pump housing by removing 3 screws. Clear any foreign matter lodged
around impeller.
5. Resemble in reverse order.
To Next Page
Loading...