What to do if my JBT Juicer will not run?
If your JBT Juicer isn't running, try the following: First, reset the breaker. Next, ensure the power cord is properly plugged in. Finally, check that all doors and covers are completely closed and securely locked.
Why is my JBT Juicer juice nozzle leaking?
If the juice nozzle on your JBT Juicer is leaking, it's likely due to a missing or damaged nozzle o-ring. You should replace the o-ring to resolve this issue.
What to do if JBT Juicer stalls and shuts off?
If your JBT Juicer stalls and shuts off, it could be due to several reasons: the cutter might be dull, the fruit being processed might be too large, the orifice tube could be damaged, or the strainer tube may need cleaning.
What to do if my JBT Juicer runs then shuts off?
If your JBT Juicer runs and then shuts off, check the door safety switches, locks, and the reservoir high-level switch to ensure they are functioning correctly.
How to fix fruit not feeding out of hopper into cup in JBT Juicer?
To resolve fruit not feeding properly from the hopper into the cup of your JBT Juicer: * Remove any wax buildup in the hopper. * Wipe the inside of the hopper with a food-grade non-stick product.
What to do if my JBT Juicer has juice in waste and/or discharge is wet?
If you notice juice in the waste or the discharge is wet in your JBT Juicer, consider the following potential causes: Check for damaged fruit, inspect the orifice tube top for damage or wear, ensure the strainer tube holes are not plugged, and verify that the fruit size is appropriate.
Why is there foam in the reservoir of my JBT Juicer?
Foam in the reservoir of your JBT Juicer can occur if the cutter is damaged. It can also be caused by mixing juice and pulp too quickly, which introduces air into the juice.
Why are there peel and seeds in the juice from my JBT Juicer?
Peel and seeds in the juice from your JBT Juicer can be caused by a missing or loose cutter, a strainer tube that is not tight in the manifold, or a damaged top of the strainer tube.
What causes fruit bursting and wet waste in JBT Juicer?
Fruit bursting and wet waste in your JBT Juicer can occur if the fruit is too large (exceeding 3-7/8"); use the hopper cover hole to measure. Also, check for any damaged fruit.
Why is the juice yield less than 2-1/2 gallons per case with my JBT Juicer?
If your JBT Juicer is producing less than 2-1/2 gallons of juice per case, it could be due to the fruit being too soft or too large. Another potential cause is damage to the orifice tube, strainer tube, and/or cutter; replace any damaged parts.
General| Brand | JBT |
|---|---|
| Model | FRESH'N SQUEEZE |
| Category | Juicer |
| Operation | Automatic |
| Fruits | Citrus fruits |
| Capacity | Varies based on usage |
| Hopper Capacity | Varies based on model |
| Power Consumption | Varies by model, typically between 0.25 - 0.75 kW |
| Dimensions (W x D x H) | Varies based on model |
| Weight | Varies based on model |
| Material | Stainless steel |
| Juice Extraction | High yield |
| Pulp Control | Adjustable |
| Cleaning | Removable parts for easy cleaning |
To Next Page