GM series cars:
1. Make the gear in P position.
2. Use cruise to choose TPMS re-learn mode in
the dashboard settings.
3. Horn will ring twice and the TPMS indicator
flashes, then the learning mode has been
successfully entered. If equipped, the message
center will display the front left (LF) tire
Ford series cars:
1. Make the gear in P position.
2. With the ignition switch to OFF, press and
release the brake pedal
3. Turn the ignition switch from the OFF position
to the RUN position 3 times and end at RUN
position
How to switch between GM and Ford
brand?
Hold the power button for 3 seconds then 2 LEDs
flashing 2 times, selected brand’s LED flashing 2
times.
How to detetied which mode the device
in?
Press the power button, if the Green LED flashing,
means Super EL50448 in GM mode, if the Yellow
LED flashing, means Super EL50448 in Ford
mode.
How to use Super EL50448?
1. Need 1x pcs 9v battery to work
2.
Set the car in TPMS learning mode. (car horns)
3. Starting from the left front tire, the antenna of
the dedicated tool for tire pressure monitoring is
facing upwards against the tire sidewall near the
rim of the valve stem to start the antenna. Press
and release the button and wait for the speaker
to emit a chirp. Once the speaker is chirping, the
sensor information is read and the turn signal to
be read at the next position will light.
4. Follow this order to rest TPMS one by one:
front left, front right, rear right, rear left.
5. After all sensors reseted, the car horns, the
TPMS re-learn finished.
How to set my car in TPMS re-learn
mode?
To Next Page
Loading...
Need help?
General