LED Error code and APP Error description:
When the controller work unnormal, the controller will show the
Error code and warning flashing, when enter the APP will pop-up
the mention box. the code explanation as below:
APP mention and error code:
Controller over current, Er01: Abnomal Working current; Check if
the pump short of voltage or the controller broken.
Controller over heat, Er02: Controller overheating; Check whether
the controller exposed to the sunshine or in high temperature
environment.
The pump dry running, Er03: Pump idling; Check the pump work
dry.
The pump was blocked, Er04: The impeller stops running, clean
the pump and impeller to ensure the impeller is clean and work
Controller overvoltage, Er05: Abnomal Working voltage; Check
the input supplying voltage.
To Next Page
Loading...
