connector is designed with standard size thread, which can be
connected to the common fountain heads and water pipes.
②
Used as dry-use pump: the pump should be placed lower
than the horizontal level to ensure water flowing into the pump.
Meanwhile, remove the front filter cover to connect the water pipe
with inlet and outlet to ensure water into the pump and pipe before
plug on.
OPERATING INSTRUCTION:
When use the pump, please pay attention to the position of the
pump. Please connect the pump supply after finishing the
installation. If the pump can’t pump the water out for the first time
which may be caused by the air in the pump body. Please try to
plug off and re-plug on to vent the air. To ensure safety, please
install a leakage switch with leakage current less than 30mA when
using outdoor (the leakage switch shall be installed by the user
self).
To Next Page
Loading...
Need help?
General
