3. Remove the two Torxt head screws holding each side
bar to the windshield frame. Shift the side bar inboard to
clear windshield pillar molding when removing the side
bar.
NOTE:
Store all of the mounting bolts in their original
threaded holes and tighten for safekeeping.
4. Unzip the sport bar padding to expose the side bar
bolts. Remove the two front and rear Torxt head screws
for each bar. Remove the side bars and rezip sport bar
padding in place.
Do not loosen or remove the adjusting bolts on the side
of the side bars. These bolts are set at the factory to
properly fit the side bar to the vehicle.
CAUTION!
Do not remove the head impact foam from the side
bars, as damage to the foam may result.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 105
3
To Next Page
Loading...
