DUAL TOP — IF EQUIPPED
If your vehicle is equipped with a Dual Top, you must
remove one of the tops from the vehicle. If the soft top
is removed, the pivot brackets must also be removed
from the sport bar. The soft top was installed at the
factory for shipping purposes only. The soft top and the
hard top are to be used independently. Removal is
mandatory to prevent any possible wear and tear on the
soft top. Your vehicle warranty will not cover damage
resulting from both tops remaining on the vehicle at the
same time for extended periods of time.
Removing The Soft Top
1. Locate and remove the two boxes that contain the
following items:
•
Right and left door frames
•
Door frame attachment knobs (four for two-door
models, six for four-door models)
•
Right and left quarter windows
•
Rear window
•
Two rear window roll up straps
•
Two Sunrider secure straps (If Equipped)
•
Two rear swing gate brackets
2. Remove the hard top. Refer to “Freedom Top Three-
Piece Modular Hard Top — Front/Rear Panel Removal”
later in this section.
120 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
