Connecting The iPod姞
Use the optional connection cable to connect an iPod威 to
the vehicle’s 16–pin connector port (which is located in
the glove compartment on some vehicles). Once the
iPod威 is connected and synchronized to the vehicle’s UCI
system (iPod威 may take a few seconds to connect), the
iPod威 starts charging and is ready for use by pressing
radio switches, as described below.
NOTE:
•
You may have to remove the connector pin protection
cap from the 16–pin connector port, prior to connect-
ing the cable.
•
If the iPod威 battery is completely discharged, it may
not communicate with the UCI system until a mini-
mum charge is attained. Leaving the iPod威 connected
to the UCI system may charge it to the required level.
Using This Feature
By using the optional connection cable to connect an
iPod威 to the vehicle’s UCI 16–pin connector port:
•
The iPod威 audio can be played on the vehicle’s sound
system, providing metadata (Artist, track title, album,
etc.) information on the radio display.
•
The iPod威 can be controlled using the radio buttons to
Play, Browse, and List the iPod威 contents.
•
The iPod威 battery charges when plugged into the UCI
connector.
Controlling The iPod姞 Using Radio Buttons
To get into the UCI (iPod威) mode and access a connected
iPod威, press the ‘AUX’ button on the radio faceplate.
Once in the UCI (iPod威) mode, iPod威 audio tracks (if
available from iPod威) start playing over the vehicle’s
audio system.
248 UNDERSTANDING YOUR INSTRUMENT PANEL
To Next Page
Loading...
Need help?
General
