EasyManua.ls Logo

Jeep 2014 Compass - Page 63

Jeep 2014 Compass
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Key Fob Programmable Features
The following features may also be programmed by using the Key Fob transmitter
or the ignition switch and driver's door lock switch.
NOTE:
Pressing the LOCK button while you are inside the vehicle will activate the Vehicle
Security Alarm. Opening a door with the Vehicle Security Alarm activated will cause the
alarm to sound. Press the UNLOCK button to deactivate the Vehicle Security Alarm.
Unlock On First Press
To unlock either the driver's side, or all doors, on the first press of the UNLOCK button:
Press and hold the LOCK button for at least four seconds, but no longer than
10 seconds. Then, press and hold the UNLOCK button while still holding the
LOCK button.
Release both buttons at the same time.
Auto Unlock Doors On Exit
To have all of the vehicle doors unlock when any door is opened:
Enter your vehicle and close all the doors, and fasten your seat belt.
Cycle the ignition switch between the LOCK and ON position four times, ending
in the LOCK position (do not start the engine).
Press the power door UNLOCK switch to unlock the doors. A single chime will
indicate that programming is complete.
Auto Door Lock
To have the doors lock automatically when the vehicle’s speed exceeds 15 mph
(24 km/h):
Enter your vehicle and close all the doors.
Cycle the ignition switch between LOCK and ON and then back to LOCK four
times, ending up in the LOCK position (do not start the engine).
Press the power door LOCK switch to lock the doors. A single chime will indicate
that programming is complete.
Sound Horn With Lock
To turn the horn chirp on or off when the doors are locked:
Press the LOCK button for at least four seconds, but no longer than 10 seconds.
Then, press the PANIC button while still holding the LOCK button.
Release both buttons at the same time.
Flashing Lights With Lock
The turn signal lights flashing, when the doors are locked or unlocked, feature can
be turned on or off. To turn this feature on or off:
Press and hold the UNLOCK button for at least four seconds, but no longer than
10 seconds. Then, press and hold the LOCK button while still holding the
UNLOCK button.
Release both buttons at the same time.
ELECTRONICS
61

Table of Contents

Other manuals for Jeep 2014 Compass

Related product manuals