To Exit Remote Start Mode And Drive The Vehicle
Before the end of 15-minute cycle, push and release the
UNLOCK
button on the RKE Key Fob to unlock the
doors and disarm the Vehicle Security Alarm (if
equipped). Then, prior to the end of the 15-minute
cycle, push and release the START/STOP
button. If
the START/STOP button is not present, insert the RKE
Key Fob into the ignition switch and turn the switch to
the ON/RUN position.
NOTE:
• For vehicles not equipped with the Keyless Enter-
N-Go — Passive Entry feature, the ignition switch
must be in the ON/RUN position in order to drive the
vehicle.
• For vehicles not equipped with the Keyless Enter-
N-Go — Passive Entry feature, the message “Remote
Start Active — Insert Key and Turn To Run” will
display in the EVIC/DID until you insert the key.
• For vehicles equipped with the Keyless Enter-N-Go —
Passive Entry feature, the message “Remote Start
Active — Push Start Button” will display in the
EVIC/DID until you push the START
button.
Remote Start Comfort Systems — If Equipped
When remote start is activated, the heated steering wheel
and driver heated seat features will automatically turn on
in cold weather. In warm weather, the driver vented seat
feature will automatically turn on when the remote start
is activated. These features will stay on through the
duration of remote start or until the ignition switch is
cycled to the ON/RUN position.
34 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
To Next Page