WARNING!
There is no anti-pinch protection when the window
is almost closed. Be sure to clear all objects from the
window before closing.
Reset AUTO-Up
Should the AUTO-Up feature stop working, the window
probably needs to be reset. To reset AUTO-Up:
1. Pull the window switch up to close the window
completely and continue to hold the switch up for an
additional two seconds after the window is closed.
2. Push the window switch down firmly to the second
detent to open the window completely and continue
to hold the switch down for an additional two seconds
after the window is fully open.
Window Lockout Switch
The window lockout
switch on the driver’s door
trim panel allows you to disable the window controls
on the rear passenger doors. To disable the window
controls, push and release the window lockout
but-
ton (setting it in the DOWN position). To enable the
window controls, push and release the window lock-
out button again (setting it in the UP position).
48 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
To Next Page