2.
The “STOP/START OFF” message will ap-
pear in instrument cluster display. Refer to
“Instrument Cluster Display” in “Getting
To Know Your Instrument Panel” in your
Owner’s Manual at
www.jeep.com/en/
owners/manuals for further information.
3. At the next vehicle stop (after turning off
the STOP/START system) the engine will
not be stopped.
4. The STOP/START system will reset itself
back to an ON condition every time the
ignition is turned off and back on.
To Manually Turn On The Stop/Start
System
Push the STOP/START Off switch (located on
the switch bank). The light on the switch will
turn off.
For complete details on the Stop/Start Sys-
tem refer to the “Stop/Start System” in the
“Starting And Operating” section located in
your Owners Manual at www.jeep.com/en/
owners/manuals.
SPEED CONTROL
When engaged, the Speed Control takes over
accelerator operations at speeds greater than
25 mph (40 km/h).
The Speed Control buttons are located on the
right side of the steering wheel.
STOP/START OFF Switch Speed Control Switches
1 — Push Cancel
2 — Push Set+/Accel
3 — Push Resume
4 — Push On/Off
5 — Push Set-/Decel
STARTING AND OPERATING
158
To Next Page
Loading...
