3
POWER SOURCES THAT
CAN BE USED
“MODE 2" CHARGING CABLE
The car may be equipped with a 100–240
volt AC (A)“Mode2” charging cable, fig.2,
which is located in a special bag in the
boot.
2 J0A6111E
The cable is composed of: a specific
charging connector (B), fig.2, for
connecting a charge status control unit (C)
to the car, which is equipped with LEDs to
provide indications of any faults that may
occur during charging, and a connection
plug (D) for a domestic power socket.
NOTE After use, remember to correctly
replace the protective cover (where
provided) on the specific charging
connector (B), fig.2, to prevent the ingress
of moisture and/or dust.
To Next Page
Loading...
Need help?
General
