Active Drive Control — If Equipped
The Power Transfer Unit (PTU) is locked to ensure imme-
diate availability of torque to the rear drive axles. This
feature is selectable in AUTO mode and automatic in the
other driving mode. 4WD LOCK can be enabled by the
following ways:
• When the 4WD LOCK button is pushed.
• When the Selec-Terrain switch is rotated from AUTO to
any other off-road modes.
Active Drive With Low Control — (Trailhawk models
only)
The 4WD LOW mode helps to improve the off-road
performance in all modes. To enable 4WD LOW, please
follow the steps below:
Enabling 4WD LOW
With the vehicle stationary, the ignition in the ON/RUN or
with the engine running, shift the transmission into NEU-
TRAL and push the button once 4WD LOW. The instru-
ment cluster will display the message ⬙4WD LOW⬙ once
the shift is complete.
Selec-Terrain Switch
Selec-Terrain Switch (Trailhawk)
6
STARTING AND OPERATING 251
To Next Page
Loading...
