Power Lumbar — If Equipped
Vehicles equipped with power driver or passenger seats
may be equipped with power lumbar. The power lumbar
switch is located on the outboard side of the power seat.
Push the switch forward or rearward to increase or de-
crease the lumbar support. Push the switch upward or
downward to raise or lower the lumbar support.
Front Heated Seats — If Equipped
The front heated seats control buttons are located within
the Uconnect system. You can gain access to the control
buttons through the climate screen or the controls screen.
• Press the heated seat button
once to turn the HI
setting on.
• Press the heated seat button
a second time to turn
the LO setting on.
• Press the heated seat button
a third time to turn the
heating elements off.
If your vehicle is equipped with automatic temperature
controls with an integrated center stack, or manual tem-
perature controls, you’ll find the heated seat switches on
the switch bank below the radio screen.
If the HI level setting is selected, the system will automati-
cally switch to LO level after approximately 60 minutes of
continuous operation. At that time, the display will change
from HI to LO, indicating the change. The LO level setting
will turn off automatically after approximately 45 minutes.
NOTE: The engine must be running for the heated seats to
operate.
Power Lumbar Switch
44 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
