EasyManuals Logo

Jeep Compass2018 User Manual

Jeep Compass2018
518 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #344 background imageLoading...
Page #344 background image
5. Uncoil the Hose and screw the fitting
at the end of the hose onto the valve
stem.
6. Turn the Mode Select Knob and turn
to the Air Mode position.
7. Check the pressure in the tire by reading the Pressure
Gauge.
If tire pressure is less than 19 psi (1.3 Bar):
The tire is too badly damaged. Do not attempt to drive the
vehicle further. Call for assistance.
If the tire pressure is 19 psi (1.3 Bar) or higher:
1. Push the Power Button to turn on
Tire Service Kit and inflate the tire to
the cold tire inflation pressure found
on the tire and loading information
label located in the driver-side door
opening.
NOTE: If the tire becomes over-inflated, push the Deflation
Button to reduce the tire pressure to the recommended
inflation pressure before continuing.
2. Disconnect the Tire Service Kit from the valve stem,
reinstall the cap on the valve stem and unplug from 12
Volt outlet.
3. Place the Tire Service Kit in its proper storage area in the
vehicle.
4. Have the tire inspected and repaired or replaced at the
earliest opportunity at your authorized dealer or tire
service center.
5. Remove the Speed Limit sticker from the steering wheel
after the tire has been repaired.
6. Replace the Sealant Bottle at your authorized dealer as
soon as possible. Refer to “Sealant Bottle Replacement”.
7
IN CASE OF EMERGENCY 343

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jeep Compass2018 and is the answer not in the manual?

Jeep Compass2018 Specifications

General IconGeneral
BrandJeep
ModelCompass2018
CategoryAutomobile
LanguageEnglish

Related product manuals