To change the level of the load floor, pull upward on the
load floor handle, pull the floor outward, and place the
back of the floor into the desired position. Lower the front
of the floor into place.
Raising The Load Floor
To raise the load floor for access of the Tire Service Kit, or
spare tire (if equipped), pull upward on the load floor
handle.
Do not raise the floor beyond the point of resistance. In
vehicles equipped with a power liftgate, forcing the floor
upward can damage the floor and vehicle’s trim panel.
To fully raise the load floor, pull upward on the floor
handle, pull the floor outward, then position the floor
upright with the bottom fitting on top of the floor position-
ing brackets. Push the top of the floor down firmly to
secure it in this position.
Cargo Load Floor Positions
1 — Upper Position
2 — Center Position
3 — Lower Position
Raised Load Floor — (Power Liftgate)
1 — Raised Load Floor
2 — Raised Floor Maximum Height
92 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
Need help?
General
