34 GETTING TO KNOW YOUR VEHICLE
7. When the half-doors are shipped with the vehicle, the
lower half-doors will have plugs in the post holes that
must be removed prior to upper half-door installation.
To remove these plugs, proceed as follows:
a. Locate the service hole in the center of each
plug of the lower half-door (two on each front and
rear door).
b. Place a tool (hook tool or trim stick is recom-
mended) in the service hole.
Place Tool Into Service Hole Of Plug To Remove
c. Using the tool, slowly pull upwards from the center
of the plug to remove.
8. Making sure the window on the upper half-door is
completely zipped closed, insert the upper half-door
into the lower half-door by placing the posts into the
post holes.
Lower The Upper Half-Door Into Post Holes
9. Push down firmly on the inside of the upper half-door
until it is fully seated in the lower half.
Push Down To Fully Seat Upper Half-Door
Door Latch Alignment
Check Door Latch And Striker Alignment
NOTE:
Only adjust the door to fit correctly against the striker.
DO NOT adjust the striker, as this could affect the
positioning of the full door.
CAUTION!
Upon first installation of the half-doors, slowly set the
door almost to the closing position and check how the
door latch aligns with the body striker. Touch condition
between these components can result in damage to
both the door and the striker.
23_JT_OM_EN_USC_t.book Page 34
To Next Page
Loading...
