92 GETTING TO KNOW YOUR VEHICLE
6. Locate the wire harness on the left rear inside corner
of the vehicle. To access the harness, remove the
plastic cover by pushing the cover to the side, and
sliding it off.
NOTE:
Do not force open; this will break the plastic cover.
Step Six
7. To release the wire harness, pull back on the
red latch (1), then push down on the black button (2)
while pulling the harness out.
Step Seven
8. Remove the hard top from the vehicle. Install the
provided edge protectors along the bottom edges of
the hard top, and place the hard top on a soft surface
to prevent damage.
9. Store the wire harness by removing the storage cover
on the quarter trim. Use the mechanical key blade to
pry the cover open.
Step Nine
10. Tuck the wire harness inside the storage
compartment, and replace the cover.
Step Ten
1 — Red Latch
2 — Black Button
CAUTION!
The removal of the Hard Top requires four adults
located on each corner. Failure to follow this caution
could damage the Hard Top.
23_JT_OM_EN_USC_t.book Page 92
To Next Page
Loading...
