A
C
B D
A. STEERING DAMPER. Provides additional steering linkage
damping necessary when vehicle is fitted with larger than
stock tires. FOX® brand, all-heavy-duty replacement for
production damper. [ 77072360AB ]
B. RING AND PINION GEARS.
Help maintain vehicle
performance after larger tires are fitted. Specifically
designed for your 2021 Jeep
®
Gladiator and went
through rigorous testing to assure peak performance
and safety while maintaining strict FCA Canada Inc.
quality requirements.
REAR SET.
4:88 ratio for use on the Dana® M220 wide rear
axle. [ 77072410 ]
FRONT SET.
(Not shown). 4:88 ratio for use
on the Dana M210 wide front axle.
[ 77072409 ]
C. RUBICON® LOCKER WIRING HARNESS. Provides factory
quality connector leads for custom builders to adapt
JT Rubicon® and Jeep Performance Parts Ultimate
Dana 44
TM
AdvanTEK® Axles equipped with electronic locking
differentials for a custom application. This connector lead
does not contain the locker position sensor circuit and is
designed for a custom switch application (not intended for
Rubicon switch adaptation). [ 77072413 ]
D. JEEP
®
PERFORMANCE PARTS ULTIMATE DANA 44
TM
ADVANTEK® AXLE ASSEMBLIES.
(1)
Made in the U.S.A. and
built strong for hard-core Jeep Gladiator off-roaders.
High-strength features include AdvanTEK Gear technology
that reduces gearset packaging with more strength and
durability, allowing for a condensed carrier and improving
ground clearance. Chromoly 4340 axle shafts, thicker
quarter-inch steel bracket mounts, thicker 9.5-mm tubes
and upgraded 1410 U-Joints also increase trail durability.
A nodular iron differential cover provides extra ribbing for
strength and increases overall rigidity. The high-clearance
carrier design adds an additional 1.27 cm (half inch) of ground
clearance, and an expanded range of gear ratios (4.56, 4.88,
5.13 and 5.38) helps accommodate for a variety of tire sizes.
The direct bolt-in axle assembly allows use of OEM components
and provides virtual plug-and-play. Includes electronic
differential lockers already installed. [ 77072529 – 4.56 Ratio ]
[ 77072528 – 4.88 Ratio ] [ 77072527 – 5.13 Ratio ] [ 77072530 – 5.38 Ratio ]
DIFFERENTIAL COVER.
(1)
(Not shown). Cast iron Differential
Cover replaces existing differential cover to provide additional
heavy-duty protection from trail damage. Features the
Jeep Brand logo. Works in conjunction with the Dana 60
Axle Assembly. [ P5160020 ]
Not all part numbers shown. See retailer for additional part numbers by vehicle application.
(1)
Mopar
®
Performance Parts are sold “as is” unless otherwise noted.
MOPAR “Jeep” Performance Parts - 2D Final Vectored Art
Approved by: Joe Dehner, Nicho Vardis
Scale: Open to Application
09-27-17
MOPAR “Jeep” Performance Parts - 2D Final Vectored Art
Designer: Chris Craey
Application: 2D Vectored Art
09-27-17
To Next Page
Loading...
