Need help?Do you have a question about the JEFF ROWLAND Model 2 and is the answer not in the manual?
General| Output Power (8 ohms) | 100W |
|---|---|
| Output Power (4 ohms) | 200W |
| Input Impedance | 100k ohms |
| Gain | 26 dB |
| Signal-to-Noise Ratio | >100 dB |
| Weight | 11.4 kg |
| Type | Solid-state |
| Frequency Response | 5Hz - 70kHz |
| THD | < 0.007% |
| Total Harmonic Distortion | <0.007 % |
| Dimensions | 89 x 483 x 318mm |
Describes the front panel standby/power button operation and illumination.
Details the rear panel switches for input impedance and overall gain selection.
Guidance on locating the amplifier and ensuring proper airflow for cooling.
Step-by-step instructions for connecting the amplifier to AC mains power.
Instructions for connecting XLR and RCA input cables, including adapter use.
Details the rear panel remote connector for switching between operational and standby modes.
To Next Page