Seats.
Both the front and rear seats are upholstered in best quality hide and will not
require any attention other than an occacional clean down with a cloth moistened
in water.
Chromium.
Wash chromium plating with soap and warm water. On no account use metal
polish.
Other attentions.
Door locks, hinges and other small working parts should be given a drop of
oil occasionally and be checked for security.
Sliding seat runners will benefit if
periodically smeared with grease.
Front Seat Adjustment.
Provision is made for 'fore and aft' adjustment of the front seats. Adjustment
is effected by pushing the control lever, located beneath the seat in a left handed
direction, easing the seat backward or forward as required. To ensure that the
seat is properly located, check that the trigger on the adjustment lever is located in
one of the adjustment apertures.
Spare Wheel Valve.
Access to spare wheel valve is obtained through hole in rear of boot floor
TOOL
KIT.
The following tool kit is supplied with the car
:-
+
in.
\c
&
in Whitworth
DIE
Spanner.
&
in.
,;
5
in.
g
in.
\*
in,
in.
X
$
in. Whitworth Box Spanner.
&in.
X
gin,
in.
X
4
in.
Tommy Bar.
Screw Driver.
Combination pliers.
4
in. Adjustable spanner.
Wheel brace.
Starting handle and bracket.
Bevelift Jack.
Tool Wrap.
Combination hammer is supplied when wire wheels are fitted.
N.B. When it is necessary to use the starting handle the bracket supplied
must be attached to the front bumper by means of the two innermost
bumper stud nuts.
PAGE
TWENTY-SEVEN
To Next Page
Loading...