Jensen EHT-707 - User Manual

Your JENSEN EHT-707 is
An extremely Powerful Active Subwoofer
with a fast, Heavy Duty 10” “monster” driver
powered by an on-board 160 Watt RMS amplifier.
Sit-on-Floor or build-into-Cabinet: With different room positioning, Bass
response can vary as Subwoofer frequencies are mainly non-directional. This being the case Sit
On Floor can locate anywhere in the room - on display or even behind the couch, If building
into Cabinet, sitting on floor with cabinet built around your EHT-707 around will provide best
results and avoid cabinet vibration, otherwise be sure to allow for these following clearances.
Subwoofer amplifier features.
LED on front panel is Purple when active and Red when on standby. Standby mode, like on
a TV draws next to no power.
80
In-Cabinet
Laying down
In-Cabinet
Upright
 1. Sit on Floor will perform better than In-Cabinet.
 2. All clearance dimensions are minimum. The more the better.
 3. Must have at least 100mm at rear as amplifier will generate heat.
 4. For In-Cabinet Laying down use rubber mat/pad for EHT-707 to sit on. This will
EHT-707
 1. Sit on Floor will perform better than In-Cabinet.
 2. All clearance dimensions are Minimum. The more the better.
 3. Must have at least 100mm at rear as amplifier will generate heat.
 4. For In-Cabinet Laying down use rubber pad/s underneath to avoid “walking”.
80mm
80
80
80
80
80mm
Tips

Summary

Subwoofer Placement and Configuration

In-Cabinet Placement

Guidance on positioning the subwoofer within furniture or cabinets, including clearance requirements.

Subwoofer Amplifier Features

LED Indicator

Describes the LED status for active and standby modes.

Subwoofer Controls and Operation

On;Off;Auto Switch

Explains the auto-sensing power function and manual modes.

Phase Control Switch

Details how to set the subwoofer phase for optimal bass.

Level Control Knob

Guidance on adjusting volume to match other speakers.

Frequency Control Knob

Instructions for setting the crossover frequency for bass response.

Line Output Sockets

Information on connecting multiple subwoofers.

Connections

Option A: Using with AV Receiver

How to connect to AV receivers in 5.1, 6.1, 7.1 systems.

Connecting to Stereo Amplifiers

Setting Level & Frequency Controls

Adding Extra Subwoofers

Warranty Information

Troubleshooting

Product Specifications

Important Notes

Jensen EHT-707 Specifications

General

Brand	Jensen
Model	EHT-707
Category	Subwoofer
Language	English