setting the Volume Control at 11 o’clock and the Frequency Control at 9 o’clock
(appx 60Hz). This setting will boost Bass information 60Hz and below–which is deep, deep Bass at
a strong (but not overpowering) level. For Home Theatre listening (movies), increase the Volume
level Control to 1 o‘clock and lower the Frequency Control to 7 o’clock (appx 40 Hz).
This will enormously enhance all Bass information 40Hz and below to a boosted Bass setting so when
dinosaurs, earthquakes and explosions kick-in, they kick in !! Refrain from turning Level Control
beyond 1 o’clock as Bass will then overpower all other music. Also, overpowering may incur
amplifier damage, Cone damage or both.
QX-95 Rear Panel Controls.
Phase Control Switch is only used if several speaker boxes are in the one room (i.e. Center
Speaker, Surrounds etc.). This Phase switch can be set to ensure the QX-95 woofer is “in phase” with
all other woofers operating together in the same room so that Bass cancellation does not occur. Once
your entire speaker system is completely set-up, flick this switch from “NOR” to “REV” and leave on
setting that provides the most Bass. This will then be correctly “in phase”. Leave switch on “REV” if
no audible increase is detected.
Video / Audio Switch As CD’s are recorded at higher gain levels than Video (DVD), this
switch provides a level adjustment. If switched to Video output from QX-95 amplifier is increased.
We suggest to leave switch to Video and adjust volume from front panel. There is no need to keep
switching this switch when changing from CD to DVD. Simply set and leave.
Line Output sockets are provided for stringing additional QX-95 subwoofers using an
additional 1RCA to 1 RCA lead. If required, you may “daisy-chain” as many as you like.
Warranty. Your QX-95 is covered under Warranty for 10 Years (amplifier 1 Year). For
Warranty claim, please return this product; with proof of purchase date back to your retailer.
QX-95 Connections.
Option A. Connecting from Prologic, AC-
Digital 5.1, 6.1, 7.1 channel receiver
Connection from your Multi-
Channel Receiver to QX-95
must be 1RCA to 1 RCA. Receiver / Amplifier
Connect to QX-95 to either
Left or Right “LOW LEVEL
INPUT”socket (both are internally
paralelled).
Sub-out
socket
QX-95 amplifier lead not
supplied
To Next Page
Loading...
