EasyManua.ls Logo

jenway 7310 User Manual

Default Icon
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Spectrophotometers
Models 7310 & 7315
Operating Manual
731 005 REV D/06-10

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the jenway 7310 and is the answer not in the manual?

jenway 7310 Specifications

General IconGeneral
TypeUV/Visible Spectrophotometer
Wavelength Accuracy±1 nm
DisplayLCD
Data OutputRS232
DetectorSilicon Photodiode
Weight3.5 kg
Power Supply100-240 V, 50/60 Hz
Light SourceTungsten-Halogen Lamp and Deuterium Lamp

Summary

Safety

Safety Precautions

General safety guidelines for operating the spectrophotometer.

SECTION 1 - Introduction

Instrument Specification

Detailed technical specifications for the 7310 and 7315 models.

SECTION 2 - Installation

Unpacking and Installation

Procedures for unpacking and setting up the spectrophotometer.

SECTION 3 – Theory and Practice of Spectroscopy Measurements

Theory of Spectroscopy Measurement

Explains UV-visible spectroscopy and the Beer-Lambert law.

Good Practice Guidelines

Recommendations for optimal performance and accurate results.

SECTION 4 – Instrument Setup

Navigating and Screen Setup

How to navigate the home screen and access menus.

Security and Setting Passwords

Functions for locking settings and methods with security codes.

Mode Selection

Restricting access to measurement modes.

SECTION 5 – Photometrics

Method Set Up

Setting up parameters for photometric measurements.

SECTION 6 – Concentration

SECTION 7 – Spectrum

SECTION 8 – Quantitation

Standard Curve

Creating and viewing standard curves.

Creating a New Standard Curve

Step-by-step process for creating a new calibration curve.

SECTION 9 – Kinetics

Mode Specific Parameters

Parameters for kinetics measurement mode.

Method Setup

Setting up kinetics measurement parameters.

Calibration

Performing zero calibration for kinetics measurements.

Sample Measurement

Performing kinetics measurements.

SECTION 12 – Maintenance and Service

Routine Maintenance

General cleaning and care of the instrument.

Lamp Replacement

Procedures for replacing tungsten halogen and xenon lamps.

Tungsten Halogen Lamp Replacement

Step-by-step guide to replacing the 7310 lamp.

Xenon Lamp Module Replacement

Note on Xenon lamp replacement for 7315 by service engineer.

Service

Contact information for technical support and repair services.

SECTION 13 – Troubleshooting

Error Codes

List of error codes, their meanings, and solutions.

Troubleshooting Guide

Common issues and their solutions.

Technical Support

Contact information for technical assistance.

Related product manuals