5-376-000106
REV. 0 - 09/07
23. Install safety chains and towing
lights.
CAUTION:
The Bottom Anchor Assembly (round tube) must never be higher
than the attachment point on the rear of the truck. The Stand Off
Bar Assembly acts as a pivot in the event of a sudden stop. This
will assure that the towed vehicle will not catapult forward onto the
deck of the MPL.
24. After the tow is complete, reverse
the procedure to unload the ve-
hicle.
25. Rotate the “CAM” handles on the
hold back bars 90° to the open
position and allow lower anchor
assembly to extend to the ground.
26. Open the underlift lockout valve,
then partially lower the boom and
underlift for easy access.
NOTE:
If the valve is not opened the
underlift tilt will not function.
Eastern Wrecker Sales Inc
To Next Page
Loading...
