Jerr-Dan MPL User Manual (English)

Other manuals for Jerr-Dan MPL

Questions and Answers:

B
Bradley CabreraJul 26, 2025
Why is the operation of my Jerr-Dan MPL so slow?
- C
  Crystal LucasJul 26, 2025
  Slow operation in Jerr-Dan Trucks can stem from several causes. It could be due to: * Low engine RPM: Speed up the engine. * Low oil level: Check the dipstick and fill with the specified oil. * Blocked or restricted hoses: Inspect and remove any blockage. * Dirty hydraulic oil: Drain, flush, and refill with clean oil, replacing the filter. * A worn hydraulic pump: Consider rebuilding or replacing it. * Clutch Pump belt slipping: Tighten or replace the belt.
S
sbookerJul 31, 2025
What to do if the remote hand controller fails to respond on my Jerr-Dan MPL?
- J
  Johnny RuizJul 31, 2025
  If the remote hand controller on your Jerr-Dan Trucks isn't responding, consider these potential causes and solutions: 1. Electric power turned off: Turn on the CONTROL power switch in the cab. 2. Not plugged in: Check the plug connection. 3. Faulty Remote Hand Controller: Use the manual controls at the rear of the body.
R
rita13Aug 5, 2025
What to do if valve solenoid(s) are sticking or frozen on my Jerr-Dan MPL?
- B
  Brian MitchellAug 5, 2025
  If the valve solenoid(s) on your Jerr-Dan Trucks are sticking or frozen, it could be due to: * A broken centering spring or being clogged with foreign material: Inspect, clean, or replace the affected parts. * Low Amperage/Voltage at Solenoid: Check the Amperage/Voltage.
J
Jasmine MartinezAug 11, 2025
Why does my Jerr-Dan MPL cylinder leak?
- A
  Andrew SuarezAug 11, 2025
  Cylinder leaks in Jerr-Dan Trucks can occur due to defective seals or rods. Inspect and replace the defective components.
K
Kelly GonzalesAug 16, 2025
Why do valve leaks occur in Jerr-Dan MPL Trucks?
- R
  Robin RobinsonAug 16, 2025
  Valve leaks in Jerr-Dan Trucks are often due to defective seals. The solution is to replace them.
J
janicebaileyAug 20, 2025
How to fix erratic cylinder function in Jerr-Dan MPL?
- F
  fkellyAug 20, 2025
  Erratic cylinder function in Jerr-Dan Trucks can be caused by: * Air in the system: Cycle the hydraulic system 10 to 15 times to remove the air. * Defective pump (pulsating): Replace the pump if necessary.