Jersey Instruments Patriot - User Manual

Jersey Instruments
Patriot
FACETING MACHINE
Features.
Variable Speed Motor, Forward and Reverse Swinging Post. (No clamping or unclamping)
Rack and Pinion to Raise and Lower Head .1 Degree Digital Angle Readout
Includes.
96, 80, 72 Tooth Index Wheels
12 Brass Dops , 3mm. to 8mm. in Flat Cone and V Form
45
0
Angle Dop. Two Setting Dops.
Transfer Block.
Available From.
Jersey Instruments Phone: 256-883-8988
805 Halstead Ct. Email: chasmusi@knology.net
Huntsville, AL USA 35803 Web: www.JerseyInstruments.com
Designed and manufactured by Jersey Instruments, 805 Halstead Ct. Huntsville, Al. 35803 USA.

Summary

Unpacking and Initial Setup

Unpacking Instructions

Check shipping container for damage and report issues. Contact carrier or factory if damage is found.

Machine Setup and Placement

Place the machine on a level surface with ample room, ensuring proper water and slurry flow.

Electrical Safety and Components

Electrical Safety Warning

Warning about lethal voltage within the control box; disconnect power before inspection.

Motor and Control System

Control Box Overview

Describes front panel controls including Forward/Reverse, Speed Control, and Digital Read-out.

Faceting Procedures and Adjustments

Pivot Block and Dop Arm

Angle Dop Usage

Setting and Checking Angles

Procedure for setting the 45° angle dop and verifying alignment with the master plate.

Lap Plate Fitting and Changing Wheels

Head Positioning and Indexing

Steps for positioning the head and setting the index wheel and dop arm relation.

Checking Squareness and Indexing

Freewheeling and Micro Adjustment

Jersey Instruments Patriot Specifications

General

Brand	Jersey Instruments
Model	Patriot
Category	Sander
Language	English