Mast Slide 7500R
User Manual
Model #07500
Thank you for choosing this product from
JessEm Tool Company. We appreciate your
support and hope that our product serves you
well. This product is designed to provide
many years of reliable service provided it is
used as intended and taken care of.
This user manual will assist you in assembly
and general operation of this product. It is
not our intent to teach you about
woodworking. It is assumed that you are an
experienced woodworker with the basic skills
and experience necessary to use this product
safely. If you are unsure or uncomfortable
about safely using this product after reading
the following instructions we urge you to seek
additional information through widely
available woodworking books or classes.
As part of our Continuous Product
Improvement Policy, JessEm products are
always advancing in design and function.
Therefore there may be differences between
what is shown in our catalogs, website or at
retail display and what is sold at time of
purchase. We reserve the right to make
positive changes to our products at our
discretion without notification.
61 Forest Plain Road,
Orillia, Ontario, Canada
L3V 6H1
Toll Free: 1-866-272-7492
Local: 705-726-8233
Fax: 705-327-0295
E
mail: jessem@jessem.com
Website: www.jessem.com
IMPORTANT!
Read and understand the contents of
this manual before assembly or
operation of this product.
IMPORTANT!
Make sure that no part of the miter
fence can make contact with the blade
or cutter and all knobs are securely
tightened before each use.
Precision Sliding Cross-Cut Table
IMPORTANT!
ALTERING THE TABLE SAW FENCE RAILS
The JessEm Mast-R-Slide 7500 is designed to
replace the left wing on a cast iron table saw.
NOTE: This sliding table accessory requires
the front and rear fence rails to be altered to
allow for the back and forth sliding motion of
the sliding table.
The installation of the Mast-R-Slide 7500
requires that the front and rear rails for the rip
fence on all saws be either relocated (moved
to the right) or cut off (shortened) so that no
part of the front and rear fence mounting rails
extend beyond the left edge of the table where
the left extension wing would mount.
To Next Page
Need help?
General