JessEm.com FOR TECHNICAL SUPPORT CALL 1-800-436-6799
Replacing Fence Faces
Over me, your fence faces may start to show
signs of wear or get damaged. At this me, the
fence faces should be replaced to ensure your
fence keeps performing the same as the day it
came out of the box.
To replace your fence faces, remove the four
knobs on the back of the fence, as shown in
gure 3. Using a hammer, lightly tap the end of
each fastener in the fence faces to remove the
carriage bolts.
Insert the carriage bolts into the new fence faces
and aach them to the fence with the four knobs.
Adjust as explained previously.
Following the drawing below, you can make your
own replacement fence faces. The original faces
that came with the fence were made out of
laminated MDF, however many materials would
work. Ideally the material will be wear resistant
and unlikely to warp over me. Torreed
hardwoods or laminated products would make
excellent choices.
To Previous Page
Loading...
