Need help?Do you have a question about the JessEm Mite-R-Excel II and is the answer not in the manual?
General| Type | Miter Gauge |
|---|---|
| Micro-Adjustment | Yes |
| Compatibility | Standard 3/4" x 3/8" miter slots |
| Height Adjustment | No |
| Miter Bar Dimensions | 3/8" x 3/4" |
| Positive Stops | 0, 22.5, 30, 45 degrees |
| Dust Port | No |
Covers operator alertness, protective gear, and appropriate attire during use.
Guidelines for a safe environment and precautions for electrical connections.
Detailed steps for assembling the flip stop component.
Instructions for connecting the assembled flip stop to the fence.
Guides attaching the handle and fence clamping T-bolts to the main unit.
Instructions for setting and tightening the guide bar in the table saw's miter slot.
Fine-tuning the guide bar fit in the miter slot using a sheet of paper.
To Next Page
