JessEm Mite-R-Excel II - Squaring the Fence to the Table - Part 1; Aligning Fence with Blade

Figure 9
Using the 3/32" Hex Key provided, attach the hex key extension (Part #63) to the Hex Key Figure
9A and insert the hex key into each of the two holes next to the Fence Locating Pin Knob and
loosen the #10-32 x 3/16" Flat Point Set Screws (Part #37). See Figure 9
Add a 3" block of wood in between the blade and flip stop (See Figure 8). **Note: You can use any
size of wood you may have lying around your shop for this step, just be sure to set your flip stop to
the appropriate length **
Slide the fence extrusion either closer or further away from the blade until the block of wood
touches the blade. The distance from the Fence to blade should be roughly 1/16" once the fence
is adjusted.
Once the fence is set, using the 3/32" Hex Key and the hex key extension provided, tighten both
of the #10-32 x 3/16" Flat Point Set Screw (Part #37)
d.
e.
f.
g.
44
6 3
63
61
37
6 1
36
37
4 0
Figure 9A
10
Make sure the gauge is set in the 0 degree position. See Figure 10
a.
Squaring the Fence to the Table
Figure 10