JessEm Mite-R-Excel II - Setting the Fence Locating Nut; Resetting Fence Locating Nut

a.
Using the directions above, use the fence locating pin knob to find the preset locating nut inside the
fence.
Once the fence locating pin knob (Part #40) is engaged into the Fence Locating Nut (Part #36) See
Figure 7, tighten the 2 Fence Knobs (Part #45).
b.
c.
** You may remove the handle (Part #10) to
complete the following steps if you choose too.
Slide the flip stop over to the 3" mark on the ruler
(See Figure 8) and lock it into place.
Figure 7
3"
Align Here
Figure 8
Ensure your table saw is OFF and UNPLUGGED before resetting the fence locating nut.
6 3
45
4 4
4 0
3 7
3 6
6 1
How To Set or Reset the Fence Locating Nut Inside the Fence
9