QUICK SETTINGS FOR SELECTED TONES
● CLEAN SETTINGS: Set the CRUNCH Master to about 6 to maximize the
amplifiers extended headroom. Now simply use the CRUNCH Preamp
control to achieve the desired tone and volume.
● HIGH GAIN SETTINGS: Switch to the OVERDRIVE channel. Initially, the
OVERDRIVE Master should be set to a low level (somewhere between 1-3)
and the OVERDRIVE Preamp turned up to give the desired gain and
distortion. Then return to the MASTER control to set the desired loudness.
● REMEMBER TO EXPERIMENT: This is how you will get the most out of your
new amplifier.
To Next Page
Loading...
