Need help?Do you have a question about the Jet Hangar A-7D/E Corsair II and is the answer not in the manual?
General| Brand | Jet Hangar |
|---|---|
| Model | A-7D/E Corsair II |
| Category | Toy |
| Language | English |
Guidance on operating high-performance R/C jet aircraft safely and effectively.
Recommendation for AMA membership and turbine waiver requirements for safe operation.
Advice on maintaining light weight by avoiding unnecessary additions during assembly.
Recommendations for surface preparation and types of adhesives for strong bonds.
List of essential tools required for assembly and maintenance of the aircraft.
List of recommended adhesives including cyanoacrylates, epoxies, and thickeners.
Detailed list of parts included in the turbine version of the A-7 Corsair II kit.
Detailed list of parts included in the ducted fan version of the A-7 Corsair II kit.
Optional accessories available for completing the ARF kit.
Step-by-step instructions for assembling the wing, including servo installation and control linkage.
Instructions for assembling the main fuselage components.
Detailed steps for installing the rudder servo and control horn for both turbine and ducted fan versions.
Specific steps for installing the rudder servo and pushrod for the turbine version.
Specific steps for installing the rudder servo and pushrod for the ducted fan version.
Instructions for mounting the elevator servos and control horns, including fuselage fitting.
Steps for installing elevator servos and pushrods for the turbine version.
Steps for installing elevator servos and pushrods for the ducted fan version.
Procedure for installing the nose landing gear, including strut, wheels, and steering cables.
Detailed steps for assembling and connecting the nose gear steering system.
Procedure for installing main gear doors using wire torsion springs and actuation arms.
Steps for installing nose gear doors with wire springs and linkage for proper closure.
Instructions for installing the fuel tank and related components for turbine engine setup.
Steps for assembling and installing the ducted fan unit, exhaust ducts, and tuned pipe hanger.
Installing the throttle servo, pushrod, and securing the tuned pipe assembly.
Installing receiver, batteries, ECU, switch, extensions, and engine pump.
Installing the accessory panel, air fill valves, receiver switch, and charge jack for ducted fan.
Procedure for balancing the aircraft at the correct center of gravity point for safe flight.
Importance and procedure for performing a radio range check before the first flight.
Advising taxi testing for ground handling feel and system checks before first flight.
Guidance for takeoff, flight control, flap/elevator mixing, and thrust line adjustment.
Detailed steps for applying special water transfer decals to the model aircraft.
Diagrams showing decal placement for the Edwards AFB A-7D scheme.
Diagrams illustrating decal placement for the VA-72 Desert Storm CAG A-7E scheme.
Notes on assembling vacuum-formed plastic cockpit parts and recommended paint colors.
Diagrams illustrating the assembly of the instrument panel, top, side, and heel floor.
Photographs showing the detail and layout of the actual aircraft cockpit.
Instructions for simple installation of scale weapons pylons, including drilling and securing.
Diagrams detailing the assembly of the inboard armament pylons.
Diagrams detailing the assembly of the middle armament pylons.
Diagrams detailing the assembly of the outboard armament pylons.
Notes on adding simple scale details to enhance the appearance of aircraft wheels.
Steps for creating and assembling scale wheel hubs, axles, and painting for the nose gear.
Steps for disassembling, painting, and reassembling Robart wheels for the main gear.
To Next Page