4
Operation
CAUTION: If the optional casters are used, make
sure they are locked in place.
To tilt table:
1. Pull out left and right handles and rotate them 90-
degrees to keep them disengaged.
2. Begin tilting front edge of table downward until it
just clears the handle pins, then turn handles 90-
degrees and allow them to slide back in.
3. Continue to tilt table slowly, while helping
stabilize the machine(s), until table passes the
beveled pins at the rear and snaps into level
position.
When machines are
mounted to table, tilt table slowly and help
stabilize the machines throughout the tilt
process. Do not allow the table to swing
uncontrollably. Failure to comply may cause
personal injury and/or unnecessary stress
upon stand components.
Machine selection
The stand will accept most bench top machines up to
load capacity and within the table size range (see
specifications). Secure the machine to the table with
appropriate fasteners (not provided). Make sure
machine(s) are securely fastened before attempting to
tilt the table.
Position of machines upon the table is user’s choice;
however, consideration should always be given to the
machines’ center of balance and weight distribution.
Ideally, they are centered upon the table. But the
design of some machines may require them to be
shifted off center for optimum position and/or easier
tilting to the down position.
(machines and user-made shelf not provided)
Specifications for JET Flip-Top Stand
To Previous Page
Loading...