Jet 728200 User Manual

JET
427 New Sanford Road
LaVergne, Tennessee 37086 Part No. M-728200
Ph.: 800-274-6848 Edition 2 03/2022
www.jettools.com Copyright © 2022 JET
728200 Flip-Top Stand
Instructions and Parts List
IMPORTANT SAFETY INSTRUCTIONS
• Review all instructions before assembling the table.
Improper assembly can cause personal injury and/or
property damage.
• Do not exceed maximum load for the stand.
• Do not stand on this product.
• WARNING: This product can expose you to
chemicals including lead and cadmium which are
known to the State of California to cause cancer and
birth defects or other reproductive harm. For more
information go to http://www.p65warnings.ca.gov.
Tools required for assembly
10mm and 16mm wrenches
(a manual ratcheting socket wrench will speed
assembly time)
Shipping contents
1 Table Assembly
4 Lower Braces (2 Long, 2 Short)
4 Vertical Legs
4 Adjustment Legs
4 Leveling Pads
1 Instructions and Parts List
1 Product Registration Card
1 Hardware Package (728200-HP)
44 Carriage Bolt M6-1.0x16 – AA
44 Flat Washer 6mm– BB
44 Lock Washers 6mm –CC
44 Hex Nut M6-1.0–DD
Assembly instructions
Use the exploded view and parts list as guides to
assembly. Make all leg and brace fasteners only
finger tight until the entire unit has been assembled.
1. Turn table assembly upside down; use a mat or
piece of cardboard underneath to prevent
scratching.
2. Assemble the four main legs (#20) to the table
brackets (#8/26). Finger tighten only.
3. Determine the height desired, then connect the
adjustment legs (#21) to the main legs. These
can be repositioned later if needed. (It is
recommended that each adjustment leg be
secured by at least 4 screws to the main leg.)
4. Determine placement of lower braces (#24/25)
and assemble them to the main legs/adjustment
legs.
5. Install the leveling foot pads (#22) and tighten
each hex nut (#23) against the adjustment leg. (If
using the optional swivel casters, install those
instead of the pads.)
6. Turn the unit over and push down lightly to make
sure stand rests evenly upon the floor.
7. Fully tighten all fasteners. Take care to not
overtighten.
Holes are provided in the lower braces for attaching a
user-made shelf, not provided.

Jet 728200 Specifications

General

Brand	Jet
Model	728200
Category	Power Tool Accessories
Language	English

Summary

Safety Information

General Safety Precautions

Review all instructions before assembly; do not exceed maximum load or stand on the product.

California Proposition 65 Warning

Warning about lead and cadmium exposure, linking to p65warnings.ca.gov for more information.

Assembly Guide

Preparation for Assembly

Lists required tools (wrenches) and all items included in the shipping contents for assembly.

Assembly Steps

Provides 7 steps for assembling the flip-top stand, from attaching legs to final tightening.

Parts List

Component Details

Comprehensive list of all components with their respective part numbers, descriptions, sizes, and quantities.

Optional Swivel Casters

Details the optional swivel casters and how to order them as an accessory.

Operation and Specifications

Tilting the Table

Step-by-step guide on how to safely tilt the table, including handle operation and stabilization.

Machine Compatibility and Mounting

Advice on selecting machines, considering their weight and balance, and securing them properly.

Technical Specifications

Provides key specifications like stock number, table size, height range, load capacity, and weight.

Recommended Machine Models

Lists JET and Powermatic models that are compatible with the 728200 Flip-Top Stand.