8
Controls and Features
Remote Control:
Time button (A, Figure 3) controls the three
different settings.
2H will light up on the back of the unit with one
press of the time button. The air filtration system
will operate for 2 hours then shut off.
4H will light up on the back of the unit by
pressing the time button twice. The air filtration
system will operate for 4 hours then shut off.
8H will light up on the back of the unit by
pressing the time button three times. The air
filtration system will operate for 8 hours then
shut off.
Speed button (B, Figure 3) controls the three
different settings; Low, Medium and High. There
is also a manual button (C, Figure 3) on the
backside of this unit which controls the speed.
On/Off button (D, Figure 3) turns the unit on and
off. There is also a manual on/off button (E,
Figure 3) on the backside of the unit. Pressing
this button will turn the machine on Low.
Overload reset switch (F, Figure 3) will pop in
the case of overload. Wait 3-5 minutes and
press the reset switch.
Changing the Filters
To reduce the risk of injury,
disconnect the air filtration unit from the
power source (unplug) before servicing or
changing filters. Failure to comply may
cause serious injury.
Outer Filter: Remove from the side of the
cabinet (A, Figure 4). This filter should be
replaced depending on the usage and
environment of your shop. JET sells a
replacement metal framed filter that can be
blown out or washed, (stock # 708724 shown in
figure 4).
Figure 3
Figure 4
To Next Page
Loading...
